Consider getting involved and helping the progress. The non-profit OpenPilot project is different. Commercial projects will charge what they can get away with, regardless of quality or features. CopterControl provides comparable functionality to other high-end autopilots at a small fraction of the cost. You won’t need to buy add-on boards or extra chip programmers. The Open Pilot project, whilst still young, it's trying to make Open Source much more user friendly. OpenPilot has made their flight controller as easy and trouble-free as possible. The new included Flexiport provides either I2C connectivity or a second serial port. The CopterControl platform has been designed from the ground up to perform a host of functions from auto-level, multi-copter, Fixed wing UAV’s and even Flybarless Helicopter support. The board shares a lot with the Revolution platform, including the powerful OpenPilot architecture and the cross-platform Ground Control Station (GCS). The CC3D is an update to the original Copter Control board, now using the powerful single chip IMU. It can fly any airframe from fixed wing to an octocopter and is configured and monitored using the powerful and user friendly OpenPilot Ground Control Station (GCS) software. The CC3D boards is an all-in-one stabilization hardware flight controller, which runs the OpenPilot firmware. CopterControl from the OpenPilot project introduces a new generation of multi-purpose aircraft stabilization platforms.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |